![background image](http://html.mh-extra.com/html/volt/val-2103-0-bbz/val-2103-0-bbz_installation-instructions-manual_1046287007.webp)
[email protected] • 813.978.3700
- 7 -
9
Install/Replace Lamp
Install Hub
8
Make sure the wire exit is facing
down on the hub, then attach
it onto the mounting surface
and secure with the self-tapping
screws.
Self-tapping Screw
Mounting
Surface
Cable
Wire
Exit Slot
Hub
Final Adjustment of Fixture Direction
Using an Allen wrench, loosen the
knuckle and adjust the fixture
up and down to your desired
direction.
Once your desired direction is
achieved, tighten the knuckle
with the Allen wrench into place.
Using a smaller Allen wrench,
loosen the smaller Allen screw
underneath the fixture to rotate
the fixture side to side. Do not
rotate 360
0
. Tighten the Allen
screw when the desired direction
is achieved.
ROTATE
Glare Guard
Glare Guard
Knuckle
ROTATE
Allen Screw
Allen wrench
Remove the glare guard and the lens to expose the MR11 bulb and replace it
with the correct wattage and type marked on the fixture label. Then,
reinstall the lens and the glare guard.
IMPORTANT: MR11 bulb must be protected from moisture and dust at all
times. Always reinstall the lens and the glare guard when removed.