INSTALLATION INSTRUCTIONS
[email protected] • 813.978.3700
w w w . v o l t l i g h t i n g . c o m
- 4 -
- 5 -
Install Stake
1
Board
Stake
Soil
Ground
Install Fixture to Stake
2
Pigtail
Wireway Slot
Lock Nut
Fixture
Wire Connections
3
Pigtail
Main Supply Cable
Grease Filled
Wire Connectors
VOLT
®
ShadowMaster™ Path & Area light
VPL-1039-Axx
Determine your desired location for
mounting the fixture. Hammer the
stake into the ground until flange
of stake is flush to grade. To avoid
damage to stake, place a board on
top of the stake while hammering.
NOTE: If the ground is hard and the
stake is difficult to install, make a
crosscut in the ground using a flat
shovel.
Clear away the area on the
ground at the wireway slot in the
top of the stake. Lay luminaire
pigtail into wireway slots and
thread the fixture into the stake.
Tighten until snug. Thread the
lock nut at the bottom end of the
fixture against the stake and hand
tighten until snug.
Strip both leads from the luminaire pigtail. Using two wire
connectors (Sold Seperately), connect leads from the luminaire
to the main supply cable leads.
Summary of Contents for ShadowMaster VPL-1039 Series
Page 4: ... 6 7 ...
