![background image](http://html1.mh-extra.com/html/u-line/h-6432/h-6432_safety-instructions_3110092001.webp)
PAGE 1 OF 9
0621 IH-6432
LED WRAP LIGHT
1-800-295-5510
uline.com
H-6432
TOOLS NEEDED
Flat Head Screwdriver
SAFETY
SAFETY INSTRUCTIONS
• Fixture can NOT be used with a dimmer switch,
motion or occupancy sensors and other electronic
switching devices unless otherwise designated.
• To reduce the risk of death, personal injury or
property damage from fire, electric shock, falling
parts, cuts/abrasions and other hazards, read all
warnings and instructions included with and on the
fixture box and all fixture labels.
• Before installing, servicing or performing routine
maintenance on this equipment, follow these
general precautions.
• Commercial installation, service and maintenance
of luminaires should be performed by a qualified
licensed electrician.
• For residential installation: If you are unsure about
the installation or maintenance of the luminaires,
consult a qualified licensed electrician and check
your local electrical code.
• DO NOT INSTALL DAMAGED PRODUCT!
• Recycle: For information on how to recycle LED
electronic products, please visit www.epa.gov
• This fixture should not be used in areas with limited
ventilation or high ambient temperatures.
• This fixture is intended to be connected to a properly
installed and grounded UL listed junction box.
• These instructions do not purport to cover all details
or variations in equipment, nor purport to provide
every possible contingency to meet in connection
with installation, operation or maintenance. Should
further information be desired or should particular
problems arise which are not covered sufficiently for
the purchaser’s or owner’s purpose, please contact
Uline Customer Service.
WARNING! To prevent risk of electric shock
or burn:
• Turn off electrical power at fuse or circuit breaker
before wiring fixture to the power supply.
• Turn off the power when you perform any
maintenance.
• Verify that supply voltage is correct by comparing it
with the luminaire label information.
• Make all electrical and grounded connections in
accordance with the National Electrical Code and
any applicable local code requirements.
• All wiring connections should be capped with UL
approved wire connectors.
• Allow fixture to cool before handling. Do not touch
enclosure or light source.
• Do not exceed maximum wattage marked on
luminaire label.
• Follow all lamp manufacturer’s warnings,
recommendations and restrictions for: driver type,
burning position, mounting locations/methods,
replacement and recycling.
• Use only lamps that comply with ANSI standards.
Wire Stripper
Hammer
Pliers
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.