Vollrath STOELTING SCBA118-37, Owner'S Manual

Page: 6 / 52

S B C A & S C B F
7
WASHING MODE
When the dispenser is in the Product Preservation mode, by
pressing key C for two seconds, the Washing mode is enabled.
In such a case, the auger turns but cooling is disabled.
Use this mode during the machine washing and sterilization to
prevent the cleaning solution from cooling.
By pressing any key, the dispenser exits from the Washing
mode and returns to the Product Preservation mode.
ALARM DISPLAY
If a fault occurs during the dispenser operation, an alarm mes-
sage is displayed. One of the elements on the density bar hop-
per flash showing the corresponding alarm number. To find a
detailed alarm list, please refer to the Service Manual.
COMPRESSOR CONDITION
The compressor condition is shown above the first density bar
of the right bowl:
- Off: Compressor off
- Flashing: Start delay timer on
- On: Compressor on
TOUCHPAD LOCK
It is possible to lock the touchpad to prevent access to the
dispenser controls by keeping keys C and D pressed together
for two seconds.
By pressing keys C and D at the same time again, the touchpad
is unlocked.
6. 3 OPERATION HELPFUL HINTS
1
The time required to make servable product varies
depending on several factors such as the ambient temperature,
the initial temperature of the product, its sugar content (degrees
Brix) and fat content and the density adjustment.
2
Filling the bowls with product that is already precooled
further increases the efficiency of the dispenser.
3
To further reduce recovery time, refill the bowls when the
level of product is below the halfway point of the evaporator.
4
To store the product correctly, the dispenser must also
operate at night, at least in the PRODUCT STORAGE position.
5
Night operation in the PRODUCT STORAGE position also
eliminates the possible formation of ice (due to condensation of
atmospheric moisture) on the outside of the bowls.
6
Never turn the dispenser off when there is product in the
bowls. If not cooled, the product may deteriorate. Furthermore,
unless it is mixed, it may stick together and form blocks of ice. If
the mixer is restarted in these conditions (without waiting for the
ice to melt), the dispenser may be damaged.
7
All dispensers of this kind emit heat. If, however, this
emission seems excessive, check that no source of heat is
located near the dispenser itself and, in particular, near the
louvered panels. Also make sure that the airflow is not impeded
by the proximity of walls, boxes or similar. Leave at least 6
inches of free space around the dispenser. Finally, check that
the filter located behind the rear panel is clean.
8
The product is for use with confectionery drinks only.
6. 4 CLEANING
1
Cleaning and washing are essential to guarantee the
perfect preservation of the taste of the product and the
maximum efficiency of your dispenser. The procedures
described below should be considered general in nature and
may vary due to local health regulations.
2
Before disassembly for washing, the dispenser must be
emptied. Proceed as follows:
- Use the touchpad to select the CLEANING operating mode.
- If necessary, wait until the product becomes liquid.
- Remove the flow restrictor from the bowl (see figure 13).
- Place a bucket under each spigot and empty the bowls.
- Fill the bowls with water and allow the dispenser to operate in
CLEANING mode for a few minutes. Then empty the bowls.
- Hold down key A to switch off the dispenser.
- Turn the main power switch OFF.
6. 4. 1 DISASSEMBLY DOUBLE-WALLED BOWL
1
Click open the two parts. (see figure 4).
figure 4
2
Remove the left-hand part and then the right-hand part of
the recover. (see figure 5) (see figure 6).
A
TTENTION
The access to the service area is restricted to persons
having safety/hygiene knowledge and practical expe-
rience on the dispenser.