Vollrath Stoelting 100C, Service Manual

Page: 41 / 52

33
SECTION 8
TROUBLESHOOTING
Troubleshooting can be difficult. The TROUBLESHOOTING INDEX on the preceding page gives a list of possible
problems. To make a repair to a problem, make reference to the cause and correction on the page indicated.
This list of problems causes and corrections will only give an indication of where a possible problem can be and what
repairs are needed. Normally, more or other repair work is needed beyond the recommendations in the list.
Remember that a problem is not normally caused by only one part, but by the relation of one part with other parts. This
list is only a guide and cannot give all possible problems and corrections. The technician must find the problem and its
source, then make the necessary repairs.
In the event the Troubleshooting Guide does not help to correct the service problem, the factory Service Department
should be contacted. Write or call:
STOELTING, INC. Tele: 920-894-2293
502 HWY. 67 800-558-5807
KIEL, WI 53042 Fax: 920-894-7029
INDEX
DESCRIPTION PAGE
8.1 Compressor run capacitor open, shorted or blown. ................................................................................. 35
8.2 Compressor relay defective or burned out .............................................................................................. 35
8.3 Compressor starts and runs, but short cycles on overload protector ...................................................... 35
8.4 Compressor runs continously ................................................................................................................. 35
8.5 Unit Noisy .............................................................................................................................................. 35
8.6 Compressor will not start ....................................................................................................................... 35
8.7 Compressor will not start - hums but trips on overload protector ............................................................ 36
8.8 Compressor starts, but does not switch off of start winding ................................................................... 36
8.9 Compressor start capacitor open, shorted or blown ............................................................................... 36
8.10 Freezer will not start ............................................................................................................................... 36
8.11 Drive motor overload trips (freezer shuts down when running) ................................................................. 36
8.12 Compressor will not run, but drive motor runs ......................................................................................... 36
8.13 Product dispenses incorrectly ................................................................................................................ 36
8.14 Product is too thin .................................................................................................................................. 37
8.15 Agitator does not rotate .......................................................................................................................... 37
8.16 No ice crystals on initial freeze down ..................................................................................................... 37
8.17 Excessive ice crystals above divider plate .............................................................................................. 37
8.18 Spigot leaking or stuck ........................................................................................................................... 37