F
ood
P
reParation
e
quiPment
3
English
O
peratOr
’
s
M
anual
1. Before grinding, verify the grinder chamber (D) is seated correctly on the
main body (C) and tighten the thumbscrew (B) counter-clockwise until
secure. See Figure 1.
nOTe:
do not use a tool to tighten the thumbscrew. Hand tighten
only.
2. Tighten the coupling cover nut (E) against the grinder chamber securely.
3. Prepare the food product. For vegetables remove stalks and stems or for
meat, remove all the skin and bones.
4. Cut the food product into appropriately sized pieces for grinding.
5. Place the tray (A) on the top of grinder chamber (D).
6. Turn the control switch (F) to the “Forward” position.
7. Use the food pusher (H) to push the food product into grinder chamber
(D). Never use fingers, hands or other objects. Feed the food product
and grind slowly at a rate that the grinder will accept. Do not force too
much product into the grinder chamber. It can overload the grinder
causing it to stop.
8. When grinding session is over turn the control switch (F) to the “OFF”
position.
nOTe:
if the unit becomes jammed or the discharge is erratic,
turn the switch to the “OFF” position. Switch to the
“reverse”position momentarily, turn the unit to the “OFF”
position. Check the following:
Thumb screw too tight; loosen and hand-tighten, do not over-tighten
Discharge plate is blocked; remove and clear
Blade edges are dull; have sharpened or replace
Overloading and motor stops; switch too and reset.
Blade is in backwards.
C
leaning
To maintain the appearance and increase the service life, clean your
equipment daily.
Grinder Chamber removal and disassembly
1. Turn the control switch to the “OFF” position and unplug from its power
source.
2. Unscrew and remove the coupling cover nut (A) from the grinder
chamber (B). See Figure 2.
A
B
Figure 2. Coupling Cover and grinder Chamber
3. Remove the grinder plate (D) from the blade shaft (A). See Figure 3.
A
C
B
d
Figure 3. grinder Plate, Cutout, locating Pin and Blade shaft
4. Carefully remove the knife blade (B) from the blade shaft (C). See
Figure 4.
C
A
B
Figure 4. Knife Blade and Blade shaft
5. Remove the worm gear assembly (B) from the grinder chamber (C). See
Figure 5.
A
C
B
d
Figure 5. shaft Washer, Worm gear Assembly and grinder Chamber
6. Remove the shaft washer (A) from the worm gear shaft (B). See Figure
