Volkswagen Motorsport
Volkswagen Golf
GTI
TCR SEQ User Manual
Volkswagen Golf GTI TCR SEQ User Manual
Page 56
Once you covered the whole filter leave the filter to stand for ten minutes to allow the detergent to
break down the old oil in the filter.
5.
Using another bucket rinse filter with cold water until no more debris collects appear at the bottom
of the bucket.
6.
Pat your filter dry and place somewhere with good air flow and allow the filter to dry naturally. Do
not use compressed air or place in a very warm area as this could damage the filter element.
7.
Once you have applied two coats of oil along both sides of the filter pleats, hold the filter and ensure
the filter is an even red colour.
8.
Once it is evenly coated, leave it stand for 30 minutes. Carefully pat the excess off the filter with
paper towels.
9.
Rebuild your filter taking care that the screw holes match up and fit it back in the car.
Air filter
Torque
Remarks
Substitution
By hand Be careful tightening the small bolts over plastic
Cleaning
Clean the cotton air filter following the procedure shown above. Do not use
compressed air or high-pressure air to clean. Use only recommended oil for
cotton filters.
Notes:
-
The air filter type and measurements are identified on the Technical Form.
It is not allowed any modification or change.
-
A clean and properly oiled air filter is basic to ensure boost’s life. It is
strongly recommended to follow the cleaning procedure as well as the
replacement frequency.
-
After rain conditions use, it is strongly recommended the cleaning or
replacement.
