background image

  2

EXMITTER EX6 Digital Radio System

The following terms are used throughout the product literature to 

indicate various levels of potential harm when operating this product.

CAUTION: Procedures, which if not be properly followed, is able to 

create a possibility of physical property damage AND or possibility of 

injury.

         Read  the 

ENTIRE

  instruction  manual  to  become  familiar           

with  the  features  of  the  product before  operating. Fail to operate 

the  product  correctly  can  result  in  damage  to  the product, 

personal property and cause serious injury. 

       This is a sophisticated hobby product and 

NOT a toy

. It  must 

be operated with caution and common sense and requires some 

basic mechanical ability. Fail to operate this Product in a safe and 

responsible manner could result in injury or damage to the product or 

other property. This  product  is  not  intended  for  use  by  children  

without  direct  adult  supervision.  Do not attempt to disassemble , 

use with incompatible components or augment product in any way 

without the approval of VolantexRC Co., Ltd.. 

This manual contains instructions for safety, operation and 

maintenance. It is essential to read and follow all the instructions and 

warnings in the manual, prior to assembly, setup or use, in order to 

operate correctly and avoid damage or serious injury. 

WARNING

 

Always ensure all batteries have been properly charged prior to 

using the model.

 

Always check all servos and their connections prior to each run.

 

Never operate your model near spectators, parking areas or any 

other area that could result in injury to people or damage of property.

 

Never operate your model during adverse weather conditions. Poor 

visibility can cause disorientation and loss of control of your model.

 

Never point the transmitter antenna directly toward the model. The 

radiation pattern from the tip of the antenna is inherently low.

 

If at any time during the operation of your model you observe any 

erratic or abnormal operation, immediately stop operation of your 

model until the cause of the problem has been ascertained and 

corrected.

Safety  Precautions

Summary of Contents for EXMITTER EX6













Reviews: