Replace the battery and push
the battery compartment back
into place.
Note that this will not
automatically power up the
device. You have to press the
screen for about 3 seconds in
order to power up the device.
Please dispose of the battery
on an environmental friendly
way (Recycle)
Figure 7: Battery replacement
3.17. Warm-up time
All instruments of red-y line are ready for use within seconds of connecting the power.
There is no significant warm-up time (<5 sec).
4. Operation
In case of incorrect handling of the flow meter the measurement function can
be impaired.
Figure 8: Horizontal mode
Figure 9 Vertical mode
4.10. Introduction
4.10.1. Power up
Before using the device verify that it is suitable for your application and
check gas, range, pressure and temperature. You find these parameters on
the calibration sheet. If any of these parameters deviate from your
application please contact the manufacturer. The flow direction indicated by
an arrow on the back side of the housing has to be respected.
The red-y compact 2 has a pressure sensitive touch screen. The device can be
operated with your fingers or a suitable touch pen that does not damage the display.
To power up the device insert a battery or connect an external power supply (USB or
24 Vdc). The device switches on automatically when connected to an external power
supply. To power up the device using a battery press the screen for about 3 seconds
until the startup screen appears.