9
This document is property of Vogel’s Products BV
Any distribution, reproduction, copying or publication of this document is prohibited.
C-
SETTING OF THE INTERMEDIATE STOP (PROJECTION MODE)
-
Lower down the lift till half stroke, pressing the remote control button
▼
and stop it with
button
◼
.
-
Press the button
◼
(for 5 secs) till the motor swivels 2 times.
-
Press again the button
◼
(for 5 sec) till the motor swivels 4 times.
-
Press simultaneously the buttons ▲+▼ (for 5 sec) till the motor swivels 2 times.
-
Press and hold the buttons
▼
or
▲
in order to the reach the desired position of the lift.
Warning: during this programming operation you have to keep the buttons
▼
or
▲
pressed in
order to reach the desired position.
-
Once this position is reached, in order to memorize it press the button
◼
(for 5 sec) till the
motor swivels 3 times.
D-
USE OF THE REMOTE CONTROL
-
Press the button
▼
in order to reach the lower-end stop (SERVICE mode).
-
Press the button
▲
in order to reach the upper-end stop.
-
Press simultaneously the buttons
▲
+
▼
in order to reach the intermediate
stop (PROJECTION mode).
E-
CONNECTION OF LOW VOLTAGE CONTACTS TO REACH THE DIFFERENT END-STOPS.
-
Close the connection, for at least 1 second, between the white-black and white-orange wires in order to
reach the LOWER end stop (SERVICE mode).
-
Close the connection, for at least 1 second, between the white-black and white wires in order to reach
the UPPER end stop.
-
Close the connection, for at least 1 second, simultaneously between the white-black, white-orange and
white wires in order to reach the INTERMEDIATE stop (PROJECTION mode).
The projector lift includes a cable management system.
In order to fit in the power and signal cables of the projector
Move the lift in the lower end stop position (SERVICE MODE),
and open the small doors, as shown in Fig. 7B.
Fig. 7B
M
O
U
IN
_P
PL
25
00
_V
3
Fig. 7A
