8
1. Connect the AC POWER ADAPTER to the UHF-3200 receiver’s POWER INPUT connector, then plug the ADAPTER
into a compatible AC electrical outlet.
2. Attach the antennas by screwing in until secure. Be sure the antennas are pointing as straight up as possible.
3. Connect the UHF-3200’s receiver to a sound system, mixer or amplifier’s microphone input(s) with ¼” output
jacks.
NOTE:
There are two options when connecting the UHF-3200 to a mixer or amplifier.
1. Independent Mic Channels
a. Connect each mic channel independently to separate input channels on a mixer or amp. Do this by
connecting a 1/4” cable from each mic channel (CH. A OUT and CH. B OUT) to individual inputs on your
mixer or amp.
2. Mixed Mic Channels
b. Use the mixed output to connect both microphone channels to a single mixer or amp channel. Do this by
connecting a 1/4” cable from the MIX OUT jack to an input jack on your mixer or amp.
Getting connected
Connecting
LEVEL
V.CANCEL
V.PARTNER
POWER
VOCAL CANCEL/PARTNER
TAPE REC.
TAPE REC.
LOW
HIGH
DSP
REVERB
DSP ECHO
SONIC
ENHANCER
IN
B OUT
B OUT
A OUT
A IN
B IN
A OUT
MIX IN
MIX OUT
UHF-3200
CH. B OUT
DC INPUT
13V-18V .300mA
ANT-IN
TNC-50
CH. A OUT
MIX OUT
CHANNEL-B
CHANNEL-A
Professional Equipment no
user serviceable parts inside
!
CAUTION
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
CAUTION: TO PREVENT ELECTRIC SHOCK,
DO NOT REMOVE COVER SCREWS
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
PERSONNEL
SERIAL NO:
www.vocopro.com
LA VERNE CALIFORNIA
U. S. A
ANT-IN
TNC-50
MIC IN
MIC IN
