13
fresh
11 Replacing The Filter Element
After a new filter element is installed, we recommend to run original
temperature water for about 3-5 minutes to rinse the filter. You can use the
safety discharge valve (if installed) or set up a 9999cc quantity through the
R2 Wireless Touch Controller.
Rotate
clockwise
to unlock
Pull
down
to remove
Push
up
to replace
Rotate
anti-clockwise
to lock
10 Checking The Status Of The Filter Element
While not operating, touch all three buttons on the
Touch Faucet for 2 seconds until you hear a long beep. Press the
Original Water
button three times, then the
Warm Water
button once. Water will be released while the Main Unit’s
display will show the following data in sequence:
Used gallons (eg 170)
Tot set gallons (eg 800)
Used time (eg 18 months)
Note: This function can only be started while on standby.
