38
41405 | 12 | 2020 | V2
10. GENERAL OPERATION
The Impuls DUO RF models work similarly to the Impuls DUO, but additional functions have
been added for communication between the energiser and the remote control.
If the energiser is completely switched off and no lights are seen, hardly any energy is
consumed. However, in this state the energiser cannot interact with the remote control.
RF models have a different switched off state in which the energiser is still ready to receive
the signal from the remote control. In this state, the control LED flashes blue every three
seconds. If it flashes red, the battery charge is low. Use the main screen to control the
selected energiser.
The selection between the devices is made using the arrow keys. Use the display to check
the fence voltage (kV). If you want to display the supplied voltage (V) instead of the fence
voltage, press the „data selection“ button (16).
At the top right of the remote you will find the energiser output button (10). With this
button you can adjust the energiser output: 100% or 50%. Your selection will be shown on
the display (8).
There are two power buttons on the remote. Hold down the red power button (15) and
turn the remote control on and off. Press and hold the energiser power button (17) to turn
the energiser on or off.
11. CALIBRATION MODE
Calibration mode assigns the energiser to a remote control.
• Turn the energiser ON, then OFF and then hold down the ON/OFF button on the energiser
for at least five seconds. In the calibration mode, the control LED flashes blue rapidly.
• Press and hold the calibration button on the remote control (13) until „P“ appears on the
display.
• Use the arrow keys to assign the energiser a desired identification number.
• Place the remote control near the energiser, within 20 cm or less, and press the
calibration button (13).
If the calibration fails, please try again.