VMAC
– Vehicle Mounted Air Compressors
Toll Free:
1-800-738-8622
Local 1-250-740-3200
Fax: 1-250-740-3201
3
2. Replacing the Air Filter
This is a dual air filter for the Kubota engine and VMAC compressor. Follow all safety precautions. For ease
of service the air filter is located just under the roof of the RAPTAIR60 behind the service panel. The filter is
also equipped with a filter minder switch at the back, and is monitored by the control system.
Clean loose dust and debris from the area around the filter cover to prevent contaminants from entering the system.
Remove the air filter cover retaining clamps and the cover.
Remove the filter element from the air cleaner housing.
Immediately cover the air cleaner housing with a clean cloth to prevent contamination entering the intake hose and
compressor.
Do not use compressed air or perform any other tasks around the filter and cover until both are replaced.
Never clean the filter element with compressed air, as this will allow some contaminates into the compressor
system. Always replace the air filter element.
Clean the inside of the cover and the air cleaner housing with a clean, dry cloth.
Do not use flammable solvents to clean the inside of the cover. If a solvent has been used rinse the cover
thoroughly with water and dry it before installing the cover. Fire in the compressor can cause an explosion.
Remove the cloth from the air cleaner housing.
Place the filter into the air cleaner housing and secure the cover with the retaining clamps.
3.
Replacing Compressor Oil
Follow all safety precautions.
Clean debris and dust from the area around the drain valve of the air/oil separator tank to prevent contamination.
Compressor Oil Filter
Compressor Oil
Drain Valve
Figure 2 - Oil Filter Location
Insert a hose over the air/oil separator tank’s drain valve outlet and open the valve to drain the oil into a container large
enough to hold at least 1-1/2 US Gallons (6 liters). After the oil has drained, close the valve.
