Vmac RAPTAIR-G30, Service Manual

Page: 25 / 96

VMAC
– Vehicle Mounted Air Compressors
Toll Free: 1-888-241-2289
Fax: 1-250-740-3201
23
Mounting with the base plate

There are four holes, near the four corners of the base plate which
can be used as mounting bolt locations. Holes can also be drilled
through the bottom of the base plate if alternate locations are
required (Figure 12).

Drill four holes in the mounting surface and secure the Gas Drive to
the vehicle. Use a minimum of four 3/8 in (10 mm) bolts. Use bolts,
washers, and locknuts or Loctite.

Remove the #8 cap from the air outlet, found near the pressure
relief valve on the WHASP tank, to the right of the battery. Connect
to the air delivery system.

There are two optional M8 Bolt holes, shown by the grey outlines
(Figure 12).
All dimensions are in inches.
Figure 12 - Mounting with base plate
24.0
6.00 8.25
6.00
12.00