HH
1003 VoIP Speaker Phone
VSMPG
5. LOADING NEW SOFTWARE
This package includes command files named
prom1.bat
through
prom4.bat
. They are
intended to be used from serial ports COM1 through COM4, respectively.
To load the new code to the board, perform the following steps:
1. Open the .zip package that contains the files. As you are reading this document,
you have probably already done that.
2. Open a command prompt, and use the CD command to go to the
Firmware/
directory where the files are.
3. Connect a serial cable between the PC and the VoIP Speaker Phone.
4. Turn the VoIP phone on. It doesn’t matter what mode it is in.
5. Check which COM port it is on.
6. If COM1, run prom1.bat by typing
prom1
and pressing the Enter key. For COM2,
run prom2.bat etc.
7. You should see roughy the following text appearing on the screen:
VSEMU 2.1 Nov 28 2007 11:50:01(c)1995-2007 VLSI Solution Oy
Clock 11999 kHz
Using serial port 1, COM speed 115200
Waiting for a connection to the board...
Caused interrupt
Chip version "1000"
Stack pointer 0x19e0, bpTable 0x7d4d
User program entry address 0x4083
eeprom.bin: includes optional header, 16 sections, 539 symbols
Section 1: code
page:0 start:80 size:3 relocs:1 fixed
[... many similar lines deleted ...]
Section 16: VS_stdiolib$0
page:0 start:689 size:134 relocs:37
0000
status
................................................................
Finished!!
Never interrupt programming!
8. Sometimes you may only see
VSEMU 2.1 Nov 28 2007 11:50:01(c)1995-2007 VLSI Solution Oy
Clock 11999 kHz
Using serial port 1, COM speed 115200
Waiting for a connection to the board...
In such a case you have either used a wrong COM port in your script or you must
change the jumper configuration as shown in Figure 5.2.
Rev. 2.20
2009-12-07
Page
19(30)