HH
1003 VoIP Speaker Phone
VSMPG
4. USING THE VOIP SPEAKER PHONE
4.4
Using as Media Player
When not connected to USB, the VoIP Speaker Phone can be used as a Media Player.
The Media Player can play back MP3, Ogg Vorbis, WMA, MIDI, IMA ADPCM and
WAV files. Frequency response for the board when used with earphones is up to 20 kHz
with good audio fidelity.
4.4.1
Setup
1. Disconnect the VoIP Speaker Phone from USB.
2. Insert an MMC/SD/SDHC card into the memory card slot.
3. Connect the VoIP Speaker Phone to a 3.7 V Li-Ion battery. You may leave the
battery always connected. It will be automatically charged when you connect the
unit to a USB power source.
4. If the unit didn’t start up automatically, push the “Power” button.
5. If you have media files on the memory card, they should now start playing from
the speaker or the earphones, depending on whether you have earphones connected
or not.
6. To turn off the unit, push the “Power” button for two seconds.
4.4.2
Using the Player
In playback mode you can skip to the previous and next audio files using the “Prev” and
“Next” buttons. You can also turn volume up and down with the “Vol. Up” and “Vol.
Down” buttons. To turn the unit off, push the “Power” button for two seconds.
4.4.3
Voice Recording
You may starting voice recording at any moment by pushing the “Record” button. When
the record light lights up, recording is on.
You may pause your recording by pushing the “Pause” button. Recording continues
when you repress “Pause”.
End recording by pushing the “Record” button again.
Never remove a memory card while recording! You will lose your recording!
Rev. 2.20
2009-12-07
Page
17(30)
