Vlano 100 PRIM, Operating Manual, Page: 7 / 20

DE
DESIGNATION KEY
100 PRIM
DC X A.
Colour:
Additional options:
_: White
V: cord switch
T: overrun switch
TH: humidity sensor and overrun switch
TP: motion sensor and overrun switch
DC: DC motor
Nozzle diameter, mm
ASSEMBLY
The fan is designed for ceiling or wall mounting for ventilation in a ventilation shaft or in a ventilation pipe with
the appropriate diameter (Fig. 2).
The installation of the fan with a direct air outlet upwards is not permitted (Fig. 2).
Installation steps of the fan:
Step 1.
Disconnect the device from the power supply and ensure that the power is switched off (Fig. 3).
Step 2.
Route the power cable to the ventilation opening (Fig. 4).
Step 3.
Remove the cover from the fan. Then remove the cover from the printed circuit board (Fig. 5).
Step 4.
Mark and drill the mounting holes and mount the fan (Fig. 6-8).
Step 5.
Connect the fan to the power supply in accordance with the connection diagram (Fig. 12).
Step 6.
Put the protective cover (Fig. 9) and the design cover (Fig. 10) back on the fan housing.
Step 7.
Reconnect the power supply to the fan (Fig. 11).
Designations of the terminals on the connection diagrams:
L: Phase (only for electrical network 220-240 V)
N: Zero (only for 220-240 V electrical network)
S: external switch
QF: Circuit breaker
LT (ST): Control chain of the timer
7th