CONNECTIONS
The XLR connectors use the following AES standard:
PIN 1 = GROUND (SHIELD)
PIN 2 = HOT (+)
PIN 3 = COLD (-)
BEFORE CONNECTING THE SPEAKER
On the back panel you will find all the controls, the signal and current inputs. At first verify that the voltage selector on the speaker is in proper
position for your country (115 Volt or 230 Volt).
The switch shall be in proper position (unless moved from unauthorized people), but a fast check will avoid problems. In case is necessary to
change the voltage please call your vendor or authorized VL Audio SERVICE CENTRE. This operation require the substitution of the fuse value
and is reserved to an RCF SERVICE CENTRE.
BEFORE TURNING ON THE SPEAKER
At this point you can connect the power supply cable and the signal cable, but before turning on the speaker make sure that the volume control
is at the minimum level (even on the mixer output). It is important that the mixer is already ON before turning on the speaker. This will avoid
damage to the speakers and noisy “bumps” due to turning on parts on the audio chain. It is a good practice to always turn on speakers at last
and turn them off immediately after the show.
Now you can turn ON the speaker and adjust the volume control to a proper level.
INSTALLATION
A 35 mm socket for mounting the loudspeaker on a speaker stand is provided in the bottom of the cabinet. VL Audio speakers MUST be used
only with approved rigging hardware.
WARNING:
Never suspend VL Audio speakers by there handles. Handles are intended for transportation, not for rigging.
WARNING:
The use of these speakers with Stand and Pole Mount accessories can be done by qualified and experienced personnel only,
trained appropriately on professional systems installations. In any case it’s the user’s final responsibility to ensure the system safety conditions
and avoid any danger or damage to people, animals and objects.
WARNING:
To use this product with the subwoofer pole-mount, before installing the system, please verify the allowed configurations and the
indications regarding the accessories, on the VL website to avoid any danger and damages to people, animals and objects. In any case, please
assure the subwoofer which is holding the speaker is located on an horizontal floor and without inclinations.
PROTECTIONS
VIVA Series active speakers are equipped with a complete system of protection circuits. Two led on the amplifier back panel indicate the
working status of the amplifier: the green led indicate that the speaker is ON and the red led is on when the protection circuit is active. The
circuit is acting very gently on audio signal, controlling level and maintaining distortion at acceptable level. If this led is ON for a long period is
better to reduce immediately the signal level from the mixer or from the speaker volume control.
VOLTAGE SETUP (RESERVED TO THE RCF SERVICE CENTRE)
200-240 Volt, 50 Hz SETUP:
FUSE VALUE T 3.15 A L 250V
2
3
1
HOT (+)
GND (Shield)
COLD (-)
BAL. XLR
IMPORTANT NOTES
www.vlsound.com
Facebook Page : VL AUDIO
