4.1 Button Operation for GPS function
NOTE: “button” presses must be less than 2 seconds each in all uses
!
This control button is at the bottom of the device
a.
On:
Press control button 5 times. The green indicating light will be on for
30 seconds. (System default as ON)
b.
Off:
Press control button 10 times. The blue indicating light will flash for 5
times
c.
Reset
:
Press control button 15 times to reset all settings. The blue
indicating light will flash for 5 times, and then the green indicating light will
be on for 30 seconds.
!
4.2 Drop Alert
!
!
5. Operation Commands Guide
!
5.1 Set APN:
(VERY IMPORTANT AND MUST BE DONE 1ST) For the
device to send data to the server, this command MUST be enabled.
!
SMS:
*apn*AXXX*BXXX*CXXX*
This command sets the telecom
A
ccess
P
oint
N
ame. BXXX refers to user name, CXXX refers to password.
!
If there is no user name and password required, send as
*apn*AXXX*
!
If there is user name but no password required, send as
*apn*AXXX* BXXX*
!
!
APN information can be checked on local telecom website.
!
You will receive the following text: "Notice: APN is set to XXX. User name: XX.
Password: XX”
!
!
5.2 Registering the “Master” Controller
SMS
to the device:
*master*1XXXXXXXXXXXX*
, (For
instance, master controller phone number is +1XXXXXXXXXXXX. +1 refers to
the country code. XXXXXXXXXXXX is the cellphone number. Please make sure
country code is included, and digit 0 is not needed before cell phone number)
!!
Device Response:
"Notice: Cell Phone # xxxxxxxxxx is set to master
controller, the password is 123456.” (The device has a default password of
“123456” to initially program in your PDA/Phone.
!
NOTE: The device will ONLY listen and respond to instructions from this
number unless you choose to turn on the multi controller function and open
the device to any cell phone number.
