7. Ensure the mount is level. Make any necessary adjustments, then
use a wrench to tighten the top 2 lag bolts.
Ensure the bottom mount holes are over a stud. Using the power
drill and the 7/32” drill bit, drill 2 holes in the bottom two mount
holes.
Drill about 2” into the studs.
8. Remove
2 lag bolts
and
2 washers
from the pouch labeled
LAG
.
Use a wrench to tighten the lag bolts and washers into the 2
holes you just drilled. Insert the lag bolts completely.
The mount is attached to the wall.
Go to Step 6 on page 16.
7
8
1
2
12
