VMA13-32 / VMT13-32
Page 8
Installation Instructions
Figure 7.
Cable Routing
Installing the Monitor
1.
Loosely tighten two (2) Phillips Head screws to the top of the mounting points.
2.
Insert the head of the screws through the keyhole slots and then secure the bottom two (2)
M4 x 10mm (or 16mm) Phillips Head screws to secure the flat panel to the mounts, then tighten
the upper M4 screws.
CAUTION
: Do not over tighten the M4 screws.
Cable Access
Please refer to Figure 7 for the correct way to route existing any cables.
Articulating Swingout Arm - After the monitor has been mounted, remove the cable access plastic covers.
Route any existing cables through these access holes. Once complete, re-insert the plastic covers.
Tilt/Pivot Mount - After the monitor has been mounted, feed the cables through the two access holes, if
desired.
Cable access
plastic covers
Display
For Smaller LCDs (13” to
15”)- M4 x 10mm Phillips
Head Screws
For Larger LCDs (20” to
32”)- M4 x 16mm Phillips
Head Screws
Figure 6
. Monitor Installation
Cable access
holes
Cable access
holes
Articulating Swingout Arm
Tilt/Pivot Mount
