VMA13-32 / VMT13-32
Page 10
Installation Instructions
Adjusting the Tilt/Pivot mount
The tilt and pivot tensions are pre-set at the factory. To alter these settings, perform the following steps.
1.
Use a M3 Allen Wrench and loosen the locking screw via the access hole (Figure 10).
2.
Remove the mount from the wall.
3.
Remove the LCD from the mount.
4.
Use the included 14mm socket to loosen (counter-clockwise) or tighten (clockwise) the adjustment
nut.
5.
Secure the LCD to the wall mount; re-attach the mount to the backplate that is on the wall.
6.
Use a M3 Allen Wrench and tighten the locking screw via the access hole (Figure 10).
Figure 9
. Tilt/Pivot Mount
Figure 10
. Tilt/Pivot Adjustments
