VIVOTEK
User's Manual - 5
Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a paper clip or thin object� Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks� Note that
all settings will be restored to factory default� Upon successful restore, the status LED will blink
green and red during normal operation�
Installation
Hardware Installation
First, use the supplied screwdriver to detach the dome cover from the camera base� Insert your MicroSD/
SDHC Card if necessary�
Then, follow the steps below to install the camera to either the ceiling or the wall:
1� Attach the supplied alignment sticker to the ceiling/wall�
2� Using the 3 screw circles on the sticker, drill 3 pilot holes into the ceiling/wall� Then hammer
the plastic anchors into the holes if necessary�
3� This Network Camera can be mounted with the cable routed through the ceiling/wall or from
the side� If you want to feed the cable through the ceiling/wall, drill a cable hole A as shown in
the picture� If the cable goes through the side of the dome cover, please remove the rubber
stopper (B)�
Network Camera
Model No: MD7530
Made in Taiwan
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Pat. 6,930,709
RoHS
V I
MAC:0002D107258A
Record the MAC address
before installing the camera�
Reset Button
Status LED
Dome Cover
Tamper-proof Screw
Camera Base
Rubber Stopper
Summary of Contents for MD7530
Page 1: ......
