Note
1. Due to different needs across countries, some phones may be single or dual SIM. The
instructions do not cover every difference between models.
2. The back cover is not removable, so as not to damage the machine.
3. Put SIM/SD card into card tray, then mount card tray into the phone. It is forbidden to
insert SIM/SD card to the phone directly.
4. You are suggested not to cut your SIM card by yourself. If the Nano card (SIM1/SIM2)
does not match, please go to the carrier to change a standard Nano card.
5. The phone uses a "Dual card dual standby single-pass" design, with means the two card
in the phone cannot be used in the same time for voice service nor data connection service.
When one of the two cards is in voice communication, the other card cannot be used to
answer any calls. If there is an incoming call to the other card, the caller may hear messages
such as "The number you called is not at service", "The subscriber you dialed can not be
connected for the moment, please redial later". When one of the two cards is in data
connection state, the other card can use the data connection service. For this reason the
above phone "Dual card dual standby single-pass" design caused, regardless of the
operator's network status. Single-channel is adopted because the phone uses single-chip
design, which can significantly improve the battery life and energy efficiency. The user is
encouraged to consult local operators to enable services like "Missed call reminder",
"Incoming call reminder" and "Secretarial service" to avoid the issue of missing calls without
alerts under the aforesaid conditions.
1.3.
Connect headphones
Plug the headphone plug into the headphone jack on the phone, ensuring that the
headphone plug is fully inserted.
1.4.
Charge phone
Insert one end of the data cable into the USB port on the phone and the other end into the
charger or a compatible device. The phone will start to charge. After charging is complete,
disconnect the phone from the charger or the compatible device and remove the charger
from the socket.
Note
Please use the data cable and charger that came with the phone.
1.5.
Antenna
This phone is equipped with a built-in antenna. Please do not touch the antenna when it is
transmitting or receiving signals. Touching the antenna may affect communication quality,
cause the phone to operate using a power level higher than needed as well as shorten the
battery life. The antenna is located inside the circle marked with dotted lines. Please do not
cover this area when holding the phone, as shown in the picture below:
A. GPS/Wi-Fi/Bluetooth antenna; B. Upper main antenna; C. Lower main antenna.
