3
ASSEMBLY STEPS
STEP 1
Measure the required mounting height using the
chart below. Ensure the front edge of the mantel
does not exceed 110°F (43°C).
STEP 2
Remove pre-installed Nuts
(A1)
, Metal Washers
(A2)
and Plastic Washers
(A3)
from Mount
(A)
using Wrench
(T-A)
.
STEP 3
(Option A)
Wood Stud Installation
Align the bottom edge of Stencil
(C)
with the measured height from step 1 and mark drilling locations
using a pencil. Use of a stud finder and level is recommended. Remove Stencil
(C)
and drill 2.2”
(55mm) deep holes using a 3/16” (4.5mm) drill bit. Attach Mount
(A)
to the wall with ST6.3x55mm
Screws
(W-A)
and Washers
(W-C)
using a 10mm socket.
TOOLS NEEDED
3/8” Drill
Pencil
Phillips
Drill
3/16” Drill
Hammer
Ruler
Stud Finder
≤ 13-3/4” (350mm)
≤ 4” (100mm)
≤ 7-7/8” (200mm)
≤ 11-3/4” (300mm)
≥ 9-7/8” (250mm)
≥ 7-7/8” (200mm)
≥ 3-1/8” (80mm)
≥ 11-3/4” (300mm)
T-A
10mm Socket
C
A
W-C
W-A
