6
The candy floss will form after roughly 30 seconds. Use a paper cone, candy stick, or other related
object to collect the candy floss. Revolve the object in a circular motion following the bowl. Turn the
object sideways directly over the heating head and continue twisting the object in order to collect the
floss into a ball shape. To continue making candy floss, repeat steps 3 and 4.
STEP 4
STEP 5
NOTE:
To prolong the
service life of the electric
motor, please allow the
motor to rest for 20 minutes
after working continuously
for an hour. Turn off the
power switch when you are
finished. Remove the pan
and clean it with water.
CLEANING
When finished making candy floss, keep machine hot and running while cleaning the heating head by
slowly pouring a small amount of water into the center.
Keep water spinning through until color inside is closer to the bare aluminum again. Allow machine
to cool, and wipe down head with a damp cloth to clean off excess sugar. Stainless steel pan may be
cleaned with warm soapy water.
If the inside of the head needs to be cleaned, remove the four screws on top, then remove top plate. If
screws are difficult to remove, turn on the machine and heater for 15-20 seconds to free up the screws.
Allow machine to heat back up for one minute before making more candy floss. This will help the
machine run well and require only minimal cleaning after each use.
REMOVING BURNT SUGAR
Due to the nature of sugar, it is normal for a small amount to burn inside even with periodic cleanings.
This will not harm the machine or candy floss produced.
Remove burnt sugar by removing top plate from heating head and allowing machine to soak in vinegar
and then scrubbing clean. An abrasive cleaning pad (such as a Scotch-Brite pad) may be used for
especially hard burns.
CHANGING THE BELT
This package includes a Spare Belt
(E)
in case the belt currently installed in the machine fails.
To access belt: Remove shields from underneath heating head. Each shield is held in place by three
screws. Remove the top cover, which is held in place by a screw on each side.
USE WITH CAUTION:
Water will immediately become steam.
