12
DU6871/DW6851/DX6831 DLP Projector - User's Manual
BLANK
3D MODE
• ON
Use the button to turn on the projector�
• OFF
Use the button to turn off the projector�
• FOCUS
Adjust the focus of the projected image�
• ZOOM
Zoom in/out the projected image�
• TEST PATTERN
Use the button to display the test image� Push to switch to
the next test image and push the EXIT button to return to the
projected image�
• LENS SHIFT
Use the button to move the lens to the right or left�
• ENTER
Use the button to select settings or confirm the changed settings.
• MENU
Push the button to display or hide the OSD menu�
• EXIT
Push the button to return to the previous menu or exit the OSD
menu�
• INPUT
Push the button to select the input source�
• PICTURE
Display Picture menu for setting up�
• NETWORK
Push the button to display LAN menu for configuration.
• AUTO SYNC
Push the button to carry out automatic signal synchronization�
• ASPECT
Push the button to display aspect ratio options�
• BLANK
Push the button to temporarily interrupt the projection�
• OVERSCAN
Push the button to select the overscan mode�
• FREEZE
Freeze/cancel the freeze of the projected image�
• LAMP MODE
Push the button to select dual lamp, Lamp 1 Lamp 2, Single�
• 3D MODE
Display the 3D settings menu�
• INFO.
Display the service menu�
• LIGHT
Push the button to turn on the backlight of the remote control�
• CLEAR: No function
• SHUTTER
Use the button to open/close the shutter�
• ID SET: No function
Remote Control
Remote Control Instructions
• Reflection may be affected by the environment under some circumstances. Aim the remote control at the project to try again if
it happens�
• Change the battery if the effective distance of the remote control is reduced or the remote control does not work�
• When the terminal of the remote control cable is inserted to the wired control terminal of the projector, the projector will
automatically switch to the wired control mode and cannot be controlled through the IR signal of the remote control� Disconnect
the wired control terminal on the projector if you want to control through the IR signal of the remote control�
• Pay attention to the installation environment because the signal may not work due to interference if the IR remote sensor is
exposed to the bright sunlight or fluorescence.
