44
Using network features
You can manage and control the projector from one or more remote computers when
they are properly connected to the same local area network.
If you are in a DHCP on environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the
projector and the other end to the RJ45 port on your Ethernet or router.
2. Press
Menu
and then go to
Source
>
Network
menu.
3. Make sure the
DHCP
is
DHCP on
.
4. Press
to highlight
Apply
and press
Enter
.
5. Please wait for around 15 - 20 seconds, and then re-enter the Wired LAN page.
The
IP Address
,
Subnet Mask
,
Default Gateway
and
DNS Server
settings will
be displayed. Note down the IP address displayed in the
IP Address
row.
Important
• If the IP Address still does not appear, contact your network administrator.
• If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default
Gateway and DNS Server settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
• If you wish to connect to the projector in its standby mode, be sure you have selected
RJ45 and obtained the IP Address, Subnet Mask, Default Gateway and DNS Server
information when the projector is on.
If you are in a Static IP environment:
1. Repeat steps 1-2 above.
2. Make sure the
DHCP
is
Static IP
.
3. Contact your ITS administrator for information on the
IP Address
,
Subnet Mask
,
Default Gateway
, and
DNS Server
settings.
4. Press
to select the item you want to modify and press
Enter
.
5. Press
/
to move the cursor and the enter the value.
6. To save the settings, press
Enter
. If you do not want to save the settings, press
Exit
.
7. Press
to highlight
Apply
and press
Enter
.
Internet
IP Router
Summary of Contents for DH765Z-UST series
Page 1: ......
