Page 3.4
Adjusting the projected image
Aspect ratio
Press
on the remote control until the image is displayed in the corect aspect
ratio.
Image quality settings
Press any of the following keys on the remote control, followed by
and
, to
adjust these image quality settings:
Brightness
Contrast
Sharpness
!
!
Notes
For more detailed information
about:
- using all the control keys
on the remote control or the
projector control panel,
- using the menus,
see
section 4. of the User
Manual: Controlling the
projector
.
For the picture setting
adjustments shown here:
- after 5 seconds, if no
adjustment has been made,
the indicator will go out and
the adjustment key must be
pressed again.
- to end the adjustment before
5 seconds has elapsed, press
a different adjustment key, or
press the key again.
Always allow the lamp to cool
for 5 minutes before:
- disconnecting the power
- moving the projector
- changing the lamp
Switching the projector off
Press POWER OFF
on the remote control or POWER
on the
"#$%&'($#)'$*(#$+)",*&+-)(.&*)"#&//)(.&)01(($*),)/&'$*2)(34&)($)'$*5#4)6$1#)
intention to switch off.
The lamp will switch of
7-),*2)(.&)"$8&#)3*23',($#)$*)(.&)'$*(#$+)",*&+)83++)9,/.)
blue for approximately 30 seconds until the lamp has cooled down.
Wait until the power indicator has switched off and the standby indicator on the
projector control panel shows amber. The projector will now be in STANDBY
mode.
Disconnect the power cable from the projector.
1.
2.
3.
