AFTER INSTALLATION
11
TRI-AXIS FINE-TUNE COMPONENT
C: 2-M4*10 PARALLEL ADJUSTMENT FIXING SCREW
FRAME 2 SLIDE
FRAME 3 SLIDE
FRAME 2
5°
INSTALLING STEP 3
BEFORE INSTALLATION
ADJUST IT AROUND TO
MIDDLE OF THE SET
POSITIONING POLE
C:2-M4*10 PARALLEL
ADJUSTMENT
FIXING SCREW
SCREENSHOT 1
SCREENSHOT 2
Installing steps of structure frame # 2:
1: Loosen “C” screw. (2-M4*10mm)
2: Decline the three axis fine-tuner by 5 degree to aim at the registration mast. As illustrated in
the following picture 2, install the slide-way on structure frame # 2’s slide-way, and switch it to
intermediate position.
3: Tighten screw “C” (2-M4-10mm) into structure frame # 2’s corresponding threaded hole
slightly, do not lock it.
4: Adjust the screw “C” to proper position and tighten it. (2-M4*10mm)
