18
2.Getting Started
Vivitek - D366/D365 Series
USER MANUAL
User Manual v1.1
Installation Guide
Verify Installation Location
●
To supply power, use the 3-blade (with earthing lead) socket to ensure proper grounding and
equalized ground potential for all Projector System equipments.
●
Use the power cord provided with the Projector. In case the item is missing, use a qualified 3-blade
(with earthing lead) power cord; DO NOT USE 2-BLADE POWER CORD.
●
Verify that the voltage is stable, grounded properly and there is no electricity leakage.
●
Measure the total power consumption and ensure it is within the safety capacity to avoid safety
issue and short circuit.
●
Turn on Altitude Mode when located in high altitude areas
●
The projector can be installed and will function properly without limitation at any angle or
orientation.
●
Ensure installation brackets are firmly secured and can support the projector weight
●
Avoid installing near air conditioner duct or sub-woofer.
●
Avoid installing in locations with high temperature, insufficient cooling and heavy dust.
●
Keep away from fluorescent lamps (>1 Meter) to avoid malfunction caused by IR interference
●
Ensure the VGA IN connector is connected tightly to the VGA IN port. The screws on both sides
securely fastened will secure the proper connection and wire signal to achieve optimal display.
●
The AUDIO IN connector should only be connected to the AUDIO IN port.
DO NOT connect to AUDIO OUT port or any other ports like BNC, RCA;
●
Before you Power ON, ensure power cord and signal cable are connected properly. To avoid
damaging the projector while starting and operating, DO NOT insert or remove the signal cable or
the power cord.
Cooling Notes
Air Outlet
●
Make sure the air outlet is 50cm clear of any obstruction to ensure proper cooling.
●
Air outlet location should not be in front of the lens of other projector to avoid causing illusions.
●
Keep the outlet at least 100cm away from the inlets of other projectors
●
The projector generates a massive amount of heat during use. The internal fan dissipates the heat
of the projector when shutting down, and such process may continue for a certain period. After
the project enters STANDBY MODE status, press the AC power button to turn off the projector
and remove the power cord. DO NOT remove the power cord during the shut-down process, as
it may cause damage to the projector. In the meantime, the delayed heat radiating will also affect
the service life of the projector. The shut-down process may vary depending on the model used.
Whatever the case may be, make sure to disconnect the power cord till after the projector enters
the STANDBY status.
Air Inlet
●
Make sure there is no object blocking air input within 30 cm.
●
Keep the inlet away from other heat sources
●
Avoided heavy dust area
