Vivint SR1410, Installation And User Manual, Page: 24 / 38

SR1410 Installation and User Guide Page 24
SR1410 Installation & User Guide Ver. 0.01
Example:
!
! Zebra configuration saved from vty - zebra.conf
! 2009/07/10 23:30:56
!
hostname mpp
password mysecret
enable password mysecret
!
interface eth0
link-detect
multicast
!
interface eth1
link-detect
multicast
!
interface lo
!
interface ra_sta0
link-detect
multicast
!
interface ra_sta1
link-detect
multicast
!
interface ra_ap0
link-detect
multicast
!
interface ra_ap1
link-detect
multicast
!
ip forwarding
ipv6 forwarding
!
!
line vty
!
!
! Zebra configuration saved from vty – ospfd.conf
! 2009/07/10 23:36:59
!
hostname mpp
password mysecret
enable password mysecret
log stdout
!
!
!
interface eth0
!
interface eth1
!
interface lo
!
interface ra_sta0
!
interface ra_sta1
!
interface ra_ap0
!
interface ra_ap1
!
router ospf
ospf router-id 192.168.249.5
redistribute connected
network 192.168.249.0/24 area 0.0.0.0
network 10.131.5.0/24 area 0.0.0.0
network 10.15.0.0/24 area 0.0.0.0
network 10.17.0.0/24 area 0.0.0.0
network 10.130.9.0/24 area 0.0.0.0
network 10.131.9.0/24 area 0.0.0.0
!
line vty
!
For each of the networks present at the mesh router, a line is inserted to instruct the OSPF protocol to
advertise the routes to its neighbor/s.
1.10.2 RIP
Distance vector Routing Information Protocol[RIP] configuration file is located at
/usr/local/etc/ripd.conf
1.10.3 IGMP
Internet Group Management Protocol[IGMP] configuration file is located at /usr/local/etc/igmpd.conf
1.10.4 PIM
Protocol Independent Multicast[PIM] configuration is located at /usr/local/etc/pimd.conf
1.10.5 BGP
Border Gateway Protocol [BGP] configuration is located at /usr/local/etc/bgpd.conf
1.11 Multicast Control
Multicast servers and clients can be on any of the node interfaces. To provision multicast rules, the
source and destination of the stream and the multicast address on which the stream flows needs to be
identified. The screen below shows a typical multicast configuration.