OmniFlow 330
5 Operation
5.1 Setting
5.1.1 Separator finger adjusting knob
As shown in the following figures. Turn the knob anticlockwise can increase the gap
while clockwise decrease the gap. When the sheets double fed, we need to decrease
the gap. When the sheets get stuck at the entrance, we should increase the gap.
5.1.2 Blowing adjusting knob
Turn the knob clockwise can weaken the blowing. When we run smaller and thinner
sheets, we can try weakening the blowing to make it fed smoothly and stably.
5.1.3 Upper limiting height adjustment for feeding table
Turn the knob clockwise the table will rise higher. If the sheets get stuck when
feeding, we can turn the knob anticlockwise a little.
Adjusting knob
Adjusting knob
Sheet
Finger
Gap
9
