P.15
energy to save. It should be set effectively before work, and once the cotton synthetic
and silk program, which have this function runs, it can’t be paused and reset.
Only cotton, synthetic and silk programs have this function.
8.Pre-wash
One washing program is added before main wash to improve the washing performance.
Only cotton program has pre-wash function.
9.Baby care
This is to increase the level of rinse water.
Baby care function can make the rinse performance better to protect the baby skin.
Except single wash, rinse, drain and spin program, the other programs can select baby
care function.
10.Spin/no spin function
The last spin speed can be selected and set.
As for model MG52-6001, the defaulted speed is 600rpm.
As for model MG52-8002, the rotating speed’s range selected through spin button can
be no spin-400-600-800rpm.
No spin means the drum rotating speed is zero after the last spin program complete its
drain stage.
During rinse, its spin speed is unchanged.
11.Wash
Single wash program.
12.Rinse
Single rinse program.
13.Spin
Single spin program. Soap liquid or rinse water shall be drained before spin.
14.Drain
During draining procedure, the clothes will only be drained but no spin to protect the
delicate and soft textiles.
2.7 Function of safety guard
2.7.1 Function of avoid overflow
When the water level is up to the abnormal height in the drum(the set warning level),
washing machines will automatically switch on drainage pump to drain by pressure
switch, even if the inlet valve failure which can not stop the inflowing water, the
washing machine will not be in the overflow. At the same time, the pressure switch will
feed back to control panel a signal of fault and the washing machine will alarm.
2.7.2 Function of avoid heating without water
When there is no water or not enough to submerge the heater, and at the same this
machine is in fault, the fuse in the heater will melt to cut off the heater and avoid danger.
2.7.3 Function of bubble checking
About wiping off bubble: When the water level is lower than level I during draining, the
2.INTRODUCTION OF PRODUCTS
