Vivax HPI-2000TP, User Manual

Page: 60 / 76

ENG
VIVAX
9
ERROR CODE
Error Code Possible Reason
E0 There is no pot/pan or unsuitable pot/pan on induction cooker.
E1 Supply voltage is too low(less than 88V).
E2 Supply voltage is too high(more than 280V).
E3 The temperature of plate surface is too high, or short circuited.
E4 Plate surface temperature sensor is not connected well.
E5
The Heat sensor of radiator (IGBT) is over heat, or short circuited, or the
fan is not connected well.
E6 The Heat sensor of radiator (IGBT) is not connected well.
MAINTENANCE and CLEANING
1. Disconnect the plug supplying electricity from the socket.
2. While Induction plate is operating or shortly after it starts operating, it is extremely
hot. You must avoid touching glass surface!
3. Never clean plate surface by the tools like hard brush, cleaning mesh or knife. Do not
use abrasive, scratching agents and detergents.
4. After cleaning with a soapy cloth, rinse it with colth and then dry thoroughly with a soft
cloth.
5. Clean the glass surfaces with special glass cleaning agents.
6. Do not clean your plate with steam cleaners.
7. Never use inflammable agents like acid, thinner and gasoline when cleaning your
oven.
WARNING:
Spilled sauce, fruit juice, etc. should be wiped off as soon as possible
with a soft cloth soaked in warm water with a detergent.
Do not allow sauces or juices to burn on the cooking plate.
This can damage the glass surface or even melt of the glass
surface or make subsequent cleaning much more difficult!
The light color change on the plate are normal and don't
have any influence on working performances.
Do not use a steel wool or knives to clean dirt deposits. Grease the
deposits with a cloth soaked with a very damp detergent, but be careful
not to scratch glass top.