Vivax CH-2004, User Manual

Page: 33 / 51

WALL MOUNTING
The heater is supplied with 4 sets of fixing brackets, screws and plastic wall
plugs to enable it to be mounted onto a wall if required.
If the heater is intended to mount onto the wall, the feet should not be fitted.
The position must be chosen carefully. It must not be in front of or below a
power socket and must not be below a shelf, curtains or any other obstruction.
Also refer to the safety instructions.
Having decided on the location of the heater it is necessary to drill 2 fixing
holes with the distance of 415mm on a horizontal line at a minimum height of
400mm from the floor, at a minimum distance of 600mm from ceiling and
300mm from side wall (see bellow) . Allowance must be made for any floor
coverings, carpet etc and if any skirting boards are present, the fixing holes
must be a minimum of 400mm above the top edge of the skirting board.
Using the plastic plugs and fixing screws provided, attach 2 of the fixing
brackets to the wall. The other pair of fixing brackets must be attached to the
base of the heater using the feet retaining screws so that the brackets project
out at the rear of the heater and space the bottom edge away from the wall.
If required, these brackets may also be secured to the wall using the remaining
fixing screws and plastic wall plugs.
CLEANING AND MAINTENANCE
To maximum the efficiency of the heater cleans regularly.

Switch power switches to “OFF” position, unplug and allow the heater to
cool.

Wipe surfaces with a soft cloth. Do not use detergent or abrasives as this
with scratch the surface.

Ensure the intake grills free front dust, as this will reduce the airflow. Light
accumulated dust can be removed with soft cloth or vacuum cleaner.

Allow surface to fully dry before using the heater again.