Vivax ACP-24CC70AERI2, User Manual

Page: 171 / 209

8
Dehumidifying operation
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the
MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the
desired temperature. The temperature
can be set within a range of 17
0
C~ 30
0
C
in 1
O
C increments.
3. Press the ON/OFF button to start the air
conditioner.
NOTE
In the Dehumidifying mode, you can not switch the
fan speed. It has already been automatically controlled.
Adjusting air flow direction
Use the SWING and DIRECT button to adjust
the desired airflow direction.
1. When push the DIRECT button, the horizontal
louver changes 6 degree in angle for each
push.
2. When push the SWING button less than 2
seconds, the louver will swing up and down
automatically.When push the SWING button
long,the louver will swing left and right
automatically.
NOTE: When the louver swing or move to a
position which would affect the cooling
or heating effect of the air conditioner,
it would automatically change the
swing/moving direction.
Mode display
Displays the current operation mode. Including
auto(
(D
), cool(
S
}<l ), dry( (| ), heat^ ) (Not
applicable to cooling only models), fan( )
and back to auto(
CJ
).
Transmission Indicator
This transmission indicator lights when remote
controller transmits signals to the indoor unit.
ON/OFF display
Displayed by pressing the ON/OFF button.
Press the ON/OFF button again to remove.
TIMER ON display
Displayed when TIMER ON time is set.
TIMER OFF display
Displayed when TIMER OFF time is set.
"Sleep Display
Displayed under sleeping operation.
Press the SLEEP button again to remove.
FOLLOW ME Display(on some models)
Displayed when FOLLOW ME function is activated.
Temp./Timer display
Displays the temperature setting(17
O
C~30
O
C). When
you set the operating mode to FAN, no temperature
setting is displayed. And if in the TIMER mode, shows
the ON and OFF settings of the TIMER.
Fan speed display
Displays the selected fan speed, AUTO(no display)
and three fan speed levels "
i t (■■■■■ " (LOW) "*t "
(MED) " S t " (HIGH) can be indicated.
The fan speed is AUTO when the operating mode is
either AUTO or DRY.
Note:
All indicators shown in the figure are for the purpose
of clear presentation. But during the actual operation
only the relative functional signs are shown on the