™
Page 50 of 59
6 Using the Accessories
6.6 Removing and Installing the Battery Tray
These procedures apply to both the Alkaline and Rechargeable battery tray.
Removing the battery tray
1. Reach under the catch and pull
to unlock.
2. Lift up the catch and repeat for
all four catches.
3. Lift the transmitter base from the
battery tray.
Installing the battery tray
The battery tray and transmitter base
have matching aligning post, contact
pins and socket.
Aligning the contact pins int their
receptacles will assure that the contact
pin will mate and not get damaged.
1. Align the aligning post and lower
the transmitter base into the
battery tray.
2. Press down on the locking catch
until it clicks, and locks in place.
Rotate the transmitter locking all
the latches.
6.7 Transmitter Modes
WARNING
Always connect the transmitter to the target line following your company's procedures. These
operations should only be performed by authorized personnel. Always make connections before
switching on the unit. Turn the transmitter off before disconnecting.
NOTE
When the 25-watt transmitter is powered on without connection leads, a “NO CONNECTION” message
will appear. Power off the transmitter and insert the connection leads, and procced with power up.
NO CONNECTION
25-Watt Transmitter (Only)