P/N: 4.04.000073
page 7 of 10
In SD mode,
In Clamp mode,
2. Screen will show a list of frequencies available, with the central one in a box.
3. Pressing the "
" or "
" pushbuttons, you can scroll up or down through the available frequencies.
4.
Once the wanted frequency is inside the box, press “f” pushbutton to select or deselect the frequency. An
“x” will appear in the box for a selected frequency.
5. After selecting the frequencies, press the "i" pushbutton again to exit
the “Frequency Menu” and return to
the main display.
6. A particular frequency in the chosen list of frequencies can be selected from the main display screen by
pressing the “f” pushbutton until the wanted frequency is displayed at the top of the main screen.
1.4.3
Multi Frequency Mode for Direct Connection
This feature can be used when user wants to energize on target two/three frequencies at the same time. Mainly,
it can be used when user is not sure which frequency can be impressed better into the target. Multi frequency
mode is not available in Fault Find and SD modes.
NOTE
When using multi frequency mode, total power will be split between the
activated frequencies.
The frequencies have to be available in the main menu.
To enter the "Multi Freq. Setup" menu, proceeds as follows:
1. Press "i" pushbutton four
times to get to the "Multi Frequency" screen and press “f” pushbutton to activate
the multi frequency mode. An “x” symbol will appear indicate the multi frequency mode is activated. Press
“f” pushbutton again to go in “Multi Freq. Setup” screen to choose the frequencies.
