7. Getting started
Before the first use please insert the provided batteries:
1. With your thumb, press on the latch located below the control
keys. With your other hand, simultaneously push the front part of
the outer casing toward the top.
2. Insert two new micro batteries 1,5 V (LR03/AAA). Observe proper
alignment of poles.
3. To reassemble the casing, position the bottom edge in place, then
gently push downward until you can hear it locking.
Attention!
Never use force!
8. Titration
8.1. Preparation for titration
1. Observe Operating Limitations and general safety regulations.
2. Adjust the length of the telescopic intake tube (according to the
bottle to be used) and push the intake tube into the intake valve
as far as it will go. Cut the lower end at an angle.
3. Screw the instrument (thread GL 45) onto the reagent bottle and
align it with the bottle label. For bottles with different thread
diameter select a suitable adapter!
Warning!
Avoid splashing of reagent! Always support both the
instrument and the bottle. Carry the mounted instrument only
as shown in figure.
8.2. Priming
Note:
If the bottle is shorter than the filling tube, separate the two
sections and cut both filling tubes to the correct length.
Warning!
Ensure that the discharge tube is pointing away from the user and
other persons at all times. Do not move the hand wheels until the
instrument has been correctly mounted, and the valve switch (12)
is in the ”recirculate” position.
24