Vitek VT-NV1600P, User Manual

Page: 4 / 100

VT-NV Series – On Cue IP
3
1. BEFORE INSTALLING
• Installation should be carried out only by qualified personnel and in accordance with electrical regulations in
force.
• The NVR must be placed on a stable surface or mounted in an approved cabinet. Adequate ventilation must be
provided, taking particular care not to block any of the air vents on the NVR.
• Adequate protection against lightning strikes and power surges must be installed to prevent damage to the NVR.
• Any safety warnings on the NVR and in these instructions must be adhered to.
• If cleaning is necessary, shutdown the NVR and disconnect the power source first. Use a soft dry cloth only –
never use an abrasive cleaner.
• Do not attempt to service or repair the DVR as opening or removing cover may expose dangerous voltages or
other hazards. Refer all servicing to qualified service personnel
1.1 UPDATING SYSTEM F/W
1.1.1 WITH THE USB THUMB DRIVE
User can upgrade the system firmware if required. F/W upgrading could be required to increase the
stability and the reliability or apply the new updated features. The following steps are a progress to
upgrade the f/w.
Verify the current F/W version
Prepare new F/W in the USB thumb drive
Do the upgrading process
1.1.1.1 How to verify the F/W version
You may need to check the F/W version provided and the F/W version currently used in the system.
From the
MANAGEMENT section under the SYSTEM menu , you can see the current version of F/W.
From the filename of the provided F/W file, you can see the version number.