5
ENGLISH
·
·
Battery recharging cycles should not exceed two hours.
Note:
– Recharge the battery only after its full discharge.
– Charge the battery at the temperature from 0° C to +35° C.
– If you haven’t used the shaver for a month or longer, fully
charge it before use.
USAGE
A fully charged battery is enough for approximately 40 min-
utes of continuous operation of the shaver.
The best shaving results are achieved if your skin is dry. Your
skin may need 2-3 weeks to get used to this shaving system.
·
·
Remove the protective cap (9).
·
·
Set the switch (4) to the «ON» position to switch on the
shaver.
Note: Only switch the shaver on if the lock button on the
switch (4) is pressed (fig. 3).
·
·
Slightly touching the skin with the shaving block (1),
move it making reciprocative motions (fig. 4).
·
·
After shaving switch the shaver off by setting the switch (4)
to the «OFF» position, cover the shaving block (1) with the
protective cap (9) and take the shaver away for storage.
·
·
It is recommended to clean the shaving block (1) after
every use.
·
·
Press the shaving block release buttons (2) and detach
the shaving block (1) (fig. 5), with the cleaning brush
(10), clean both sides of the shaving block, then clean
the inner shaving blocks.
·
·
Install the shaving block (1) into its place.
Using the trimmer (fig. 6)
The trimmer is intended for trimming sideburns and mustache.
·
·
Move the trimmer lock (7) upwards.
·
·
Set the switch (4) to the «ON» position to switch on the
shaver.
·
·
Place the trimmer under the right angle to your skin and
move it gradually downwards to trim mustache or side-
burns.
·
·
Switch the shaver off by setting the switch (4) to the
«OFF» position and close the trimmer by pressing on it.
CLEANING AND MAINTENANCE
Clean the shaving block (1) after every use or after several
operation cycles of the shaver.
·
·
Clean the shaver body (3) with a soft, slightly damp
cloth, and then wipe it dry.
IM VT-8269_70x130.indd 5
21.05.2018 10:06:22