Vitek VT-8236, Instruction Manual

Page: 6 / 36

6
ENGLISH
•
Unwind the power cord completely.
•
Install one of the attachments (1) or (8). To do this,
insert the attachment into the installation place (2).
If the attachment is set properly, you’ll hear the lock (3)
clicking.
•
Before switching the unit on, make sure that your home
mains voltage corresponds to the unit operating voltage.
•
The unit is intended for operation with AC system and
50 Hz or 60 Hz frequency, the unit does not need any
additional settings for operating with the required nomi-
nal frequency.
USING THE HOT AIR STYLER
•
Make sure that the operation mode switch (4) is set to
the position «0».
•
Insert the power plug into the mains socket.
•
Set the required settings of the air flow using the switch (4):
«0» – the hot air styler is off;
«
» – «cool» air supply;
«1» – low air flow temperature;
«2» – high air flow temperature;
Note: During the first operation some foreign smell and a
small amount of smoke from the heating element are pos-
sible, this is normal.
•
After the hot air styler operation is finished, switch it off
by setting the switch (4) to the «0» position and unplug it.
•
Wait till the hot air styler cools down.
•
Remove the attachment; to do this, press on the lock (3)
and remove the attachment.
•
Periodically straighten the cord if it gets twisted dur-
ing operation.
Overheating protection
Overheating protection switches the hot air styler off if the
temperature of the outgoing air is above the limit.
If the hot air styler is switched off during operation, set the
switch (4) to the «0» position, unplug the unit and make sure
that the inlets and outlets are unblocked.
Let the unit cool down for 5-10 minutes and switch it on
again. Do not block the air inlets during the hot air styler
operation and avoid getting of hair into the air inlets (6).
IM VT-8236_70x130.indd 6 25.02.2019 14:07:47