Vitek VT-8200 BN, Instruction Manual

Page: 4 / 20

4
ENGLISH
of a person who is responsible for their safety
and if they are given all the necessary and
understandable instructions concerning the
safe usage of the unit and information about
danger that can be caused by its improper
usage.
• Do not leave children unattended to prevent
using the unit as a toy.
•
For children safety reasons do not leave
polyethylene bags used as packaging unat-
tended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
• Do not attempt to repair the unit. Do not dis-
assemble the unit by yourself, if any mal-
function is detected or after it was dropped,
unplug the unit and apply to any authorized
service center from the contact address list
given in the warranty certificate and on the
website www.vitek.ru.
• Transport the unit in the original package only.
•
Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
USING THE HAIRDRYER
After unit transportation or storage at low
temperature it is necessary to keep it for at
least two hours at room temperature before
switching on.
• Unpack the hairdryer and remove any stick-
ers that can prevent unit operation.
• Unwind the power cord completely.
•
Before switching the unit on, make sure that
your home mains voltage corresponds to the
unit operating voltage.
• Insert the power plug into the mains socket.
Switching hair dryer on
Before switching the appliance on make sure
power supply voltage meets operating voltage
of the appliance.
• Insert power cord plug into wall outlet.
• Select operating speed you need using air-
flow speed switch (1):
1 = high speed;
2 = low speed;
0 = switched off.
• Select airflow temperature you need using
heating degree switch (2).
1 = slight heating
2 = medium heating
3 = maximal heating
Taking care about your hair
Before drying and setting your hair, wash them
with shampoo, dry with towel to remove exces-
sive moisture and brush for better results.
Fast drying
Set switch (2) into position of maximal heating
(position III), select airflow speed you need us-
ing switch (1) and dry your hair out a little bit.
Shake off excessive moisture by hand or using a
brush and continuously move the hair dryer over
your hair.
Straightening your hair
Set switch (2) into position of maximal heat-
ing (position III), select airflow speed you need
using switch (1) and dry your hair out a little
bit. When your hair are almost dry, install con-
centrating nozzle (6), reduce degree of air
heating by switch (2) and airflow speed by
switch (1).
Divide your hair in locks and layers, and start
straightening them from lower layers upwards.
Bruch hair downright using round or flat brush,
simultaneously directing hot air blowing from
concentrating nozzle on them. Straighten each
lock from root to tip this way. After you have fin-
ished straitening locks of the lower layer, start
processing the locks of medium layer, and so
on, and finish with straitening locks of the up-
per layer.
Natural waving structure of your hair
Set switch (2) into position of slight heating (po-
sition I), then set switch (2) into position I, hold
a lock between your fingers tightly, turn it to di-
rection of its natural curliness, then dry the lock
out by directing air jet between the fingers. After
getting the shape you need, press cool shot but-
ton COOL (2) and fix each lock.
Rising up and volume
Using hair dryer in any mode of heating/any
speed from slight to maximal, dry out hair roots
beginning from backside of your head.
IM VT-8200.indd 4 28.11.2016 17:34:41