Vitek VT-7128 BK Manual Instruction Download

Page: 4 / 20

ENGLISH

the warranty certificate and on the website
www.vitek.ru.

•

To avoid damages, transport the unit in the
original package only.

•

For environment protection do not discard the
unit with usual household waste after its ser-
vice life expiration; apply to a specialized cen-
ter for further recycling.

•

Keep the unit out of reach of children and dis-
abled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY

BEFORE THE FIRST USE

After unit transportation or storage at low
temperature keep it for at least 3 hours at
room temperature before switching on.

–

Unpack coffee grinder.

–

Before using the unit, make sure that your
home mains voltage corresponds to the unit
operating voltage.

–

Remove the ground coffee container (1) with
the lid (10) pulling it towards you.

–

Remove the coffee bean container lid (6),
turn the container (5) counterclockwise and
remove it.

–

Remove the upper millstone (12) turning it
clockwise in the «unlock» direction.

–

Carefully wipe the lower millstone.

–

Wash all removable parts with warm water
and a neutral detergent, then rinse and dry
thoroughly.

–

Clean the coffee grinder body (3) with a soft,
slightly damp cloth, and then wipe it dry.

–

Install the upper millstone (12) back to its
place turning it counterclockwise in the «lock»
direction until bumping.

–

Install the coffee bean container (5), turn it
clockwise until bumping and cover it with the
lid (6).

–

Close the ground coffee container (1) with the
lid (10) and install the container to its place
securely.

USING THE COFFEE GRINDER
The maximal continuous operation time is
1 minute with a 5 minute subsequent break.

–

Make sure that all removable parts are
installed properly.

–

Open the lid (6) and put the coffee beans into
the container (5). There is a scale on the inner
surface of the container (5) which allows to

match the amount of coffee beans and num-
ber of cups of the ready drink.

Note:

–

Do not put more than 80 g coffee beans into
the container (5).

–

the ground coffee scale in “cups” inside the
container (5) is approximate, if the amount of
ground coffee is insufficient, add more cof-
fee beans and switch the coffee grinder on.

–

Cover the container (5) with the lid (6).

–

Turn the control knob (4) to select the required
grinding degree on the scale (7) «FINE»,
«MEDIUM», «COARSE»:
«FINE»

–

grinding degree for pump-driven

coffee makers;
«MEDIUM»

–

medium grinding for drip cof-

fee makers;
«COARSE»

–

coarse grinding for brewing cof-

fee in the coffee pot.

–

The indicator (8) shows the selected grind-
ing degree.

–

Unwind the power cord completely and insert
the power plug into the mains socket.

–

Switch the unit on by pressing the button (9).

Note:

–

before switching the unit on make sure that
the containers (1 and 5) are installed prop-
erly and covered with the lids (6 and 10), oth-
erwise the coffee grinder will not switch on;

–

if  during  the  coffee  grinder  operation  the
coffee  beans  do  not  reach  the  millstones,
it  is  recommended  to  slightly  tilt  the  coffee
grinder or shake it carefully.

–

The coffee grinder is switched off automati-
cally.

–

If during the operation the coffee bean con-
tainer (5) becomes empty or if you need to
switch the coffee grinder off immediately,
press the on/off button (9) again.

–

Unplug the unit after operation.

–

For the best taste of the ready drink grind
only necessary amount of coffee beans right
before the coffee making.

–

To prevent the flavour degradation of ground
coffee keep the fresh-ground coffee in tightly
closed jars or in a vacuum package.

CLEANING AND STORAGE

–

Unplug the coffee grinder before cleaning.

–

Disassemble the coffee grinder as described
in the chapter “BEFORE THE FIRST USE”.

–