ENGLISH
6
Auto search
Using buttons VOL+ / VOL- you can start automatic search beginning from channel 0, range by
range, MW-, MW-2 (meter waves), DMW (decimeter waves). After the channel with sufficient level
of signal has been found, search is stopped and cannel is memorized.
In order to get sharp picture it is recommended to do the following:
. Select screen menu you need.
2. Set corresponding color and sound systems.
. Perform auto search.
Notice:
In order to provide the best receive try several variants of telescopic antenna placement. Low quality
picture, presence of noise is not the sign of TV-set malfunction. In case of weak signal while using
telescopic antenna try to connect external antenna by using proper adapter.
Trouble shouting
In case of malfunction check the following causes in the table below before turning to the service
center.
Problem
Possible cause
There is no picture or
sound
• Check if AC or car adapter is connected correctly. Use only adapters
included into delivery set.
• Check if TV-set is not in standby mode.
There is no picture
• Check if the channel is selected correctly. Perform channel auto search.
For each new place the channel tuning is required.
There is no sound
• Make sure the volume level is not minimal.
• Make sure the volume is not switched off.
• Make sure the head phones are disconnected.
Picture is too dark
• Check “Brightness” and “Contract” settings.
Fuzzy picture
• Make sure the antenna is connected properly.
• Weak signal.
There is no picture or
sound, only noise
• Make sure the antenna is connected properly.
• Weak signal.
Noise of “snowing”
type
• Placement near motor road, railway or high-voltage line, neon lights, etc.
• Interference caused by proximity between the antenna cable and the
power supply cable. Install these cables at a distance from each other.
Remote Control is not
working
• Check batteries in remote control; replace them if necessery.
Monochrome picture,
fuzzy picture
• Make sure that the picture settings are correct, and the color system is
chosen properly.
• Weak signal.
• Bad quality of the program.
• Make sure the antenna is connected properly.
Upturned picture
Check “Picture mirror” and “Picture up and down” settings.
5016IM.indd 6
21.02.2008 11:25:59
