D. Adjust VOLUME CONTROL (11) and TONE CONTROL (10) to desired level.
E. Press FAST FORDWARD BUTTON (3) on deck firmly in case you want to forward tape.
F. Press REWIND BUTTON (4) on deck firmly in case you want to rewind tape.
G. When tape comes to an end in play mode, tape playback will be automatically switched
off.
Note:
L Press the PAUSE BUTTON (1) on deck to pause the playing.
L Press the STOP/EJECT BUTTON (2) to stop the playing, press the button again to open
the cassette door, you can take out the tape.
L Please set the FUNCTION SWITCH (9) to 'TAPE" position.
BUILT IN MIC RECORDING
A. Install a cassette tape into deck B.
B. Place FUNCTION SWITCH (9) to 'TAPE" position.
C. Depress RECORD BUTTON (6) and PLAY BUTTON (5) on deck simultaneously.
Recording then starts through the BUILTLIN CONDENSER MICROPHONE (12).
D. To end recording, press STOP/EJECT BUTTON (2) on deck or it will automatically stop
when the cassette runs to the vary end.
MIC MIIXING JACK
This jack accepts any dynamic microphone has its impedance between 600 and 300
ohms, with 3.5mm diameter standard plug. Voice through external microphone to mix
with another sound source while playing or selected.
NOTE: ALWAYS DISCONNECT THE EXTERNAL MICROPHONE WHEN THE EXTERNAL
MICROPHONE IS NOT USE. IF HOWLING OCCURS, MOVE THE EXTERNAL MICROL
PHONE FAR AWAY FROM SPEAKERS AND/OR DECREASE VOLUME LEVEL.
RADIO RECORDING
A. Install a cassette tape into deck.
B. Place FUNCTION SWITCH (9) to "RADIO" position. After selecting the desired band
and tune the TUNING KNOB (15) to desired broadcast station. Then push down RECORD
BUTTON (6) and PLAY BUTTON (5) on deck simultaneously.
C. After recording the desired broadcast, depress the STOP/EJECT BUTTON (2) lightly,
and then place FUNCTION SWITCH (9) to 'TAPE" position in order to listen to the recordL
ed broadcast.
D. If you desire to play recorded broadcast, please follow the instructions explained in
playback section.
ERASURE. When you record over previously recorded tape, the original recording is autoL
matically erased and replaced by this newly recording material.
HEADPHONE JACK
For private listening, insert a 3,5mm headphone (not included) into the HEADPHONE
JACK (7). The SPEAKERS (21) output is automatically cut off.
CAUTION: LISTENING AT HIGH POWER FOR A LONG MOMENT COULD DAMAGE USERS'
EARS.
ENGLISH
ЧИСТКА ГОЛОВОК
Для обеспечения нормальной работы магнитофона регулярно чистите
лентопротяжный механизм (прижимной резиновый ролик, магнитные головки,
направляющие валики и стойки). Чистку следует производить тампоном,
смоченным в спирте или специальной жидкости. Не используйте для чистки
ворсистые ткани, любые абразивные материалы и растворители.
Загрязнение механизма зависит от качества магнитной ленты, поэтому
используйте только кассеты известных производителей.
СПЕЦИФИКАЦИЯ
Питание
AC 220 В ~ 50 Гц;
DC UML1(D) x 6;
Частотные диапазоны
FM1 64 L 87 МГц;
FM2 88 L 108 МГц;
LW 150 L 260 КГц
СРОК СЛУЖБЫ МАГНИТОЛЫ НЕ МЕНЕЕ 3Х ЛЕТ
РУССКИЙ
5
12
VT-3206.qxd 25.09.03 16:07 Page 10
