Vitek VT-2578, Manual Instruction

Page: 7 / 36

7
ENGLISH
Hair cutting
–
The hair should be clean and dry.
–
Before cutting hair, switch the hair clip-
per on by setting the power switch (3) to
the position «I».
–
Make sure that the hair clipper operates
normally and the blades move smoothly.
If there is excess oil on blades, remove it
with a dry cloth or a paper tissue.
–
Switch the unit off by setting the switch
(3) to the position «O», then install the
universal attachment (8).
–
Seat a person so that his/her head is
approximately at your eye level, cover
the person’s shoulders with a towel and
set hair with the comb.
–
Switch the unit on by setting the power
switch (3) to the position «I».
–
After you finish using the unit, set the
power switch (3) to the position «O».
Notes:
–
Always switch the hair clipper off during
breaks between the operation cycles.
–
Switch the hair clipper off before
removing the attachment (8).
Reminders:
•
Cut off a little amount of hair at a time;
you can always return to the cut part for
additional cutting.
•
The best haircutting results are reached
on dry hair, not wet.
•
Comb the hair with a comb to reveal
uneven locks.
•
It is better to leave longer hair after cut-
ting for the first time.
•
After learning the unit better, you will
be able to arrange your hair in any style
you need.
HAIR STYLING INSTRUCTIONS
Step one
Set the universal attachment (8) to the posi-
tion «3» or «6». Switch the hair clipper on,
setting the power switch (3) to the position
«I». Hold the hair clipper with the blades
pointed upwards. Start cutting from the
lower part of the head. Slowly move the hair
clipper upwards. Cut the head back area at
the bottom and near the ears (pic. 9, 10, 11).
Step two
Switch the hair clipper off, set the attach-
ment to the position «9» or «12», switch the
hair clipper on and continue cutting hair
closer to the top of the head (pic. 12).
Step 3 – cutting in the temples area
Switch the hair clipper off, set the
attachment to the position «3» or «6» and
cut hair on the temples. Then set it to the
position «9» or «12» and continue cutting
towards the top of the head.
Step 4 – cutting the top of the head
Using the universal attachment (8), cut the
hair from the top of the head towards the
crown against the hair growth direction.
•
You can cut hair against and along the
direction of hair growth, but keep in
mind that the hair cut against the growth
will be shorter than the hair cut along
the growth.
•
Use the attachment (8) positions «3» or
«6» for very short cutting. To leave lon-
ger hair, use the attachment (8) posi-
tions "from 9 to 18".
•
To leave longer hair, grip hair locks
between your fingers and cut the hair off
using the clipper (pic. 13).
•
You may use a comb: lift the hair locks
and cut them with the hair clipper over
the comb (pic. 14).
•
Always start cutting from the head back.
•
Comb the hair to reveal uneven locks.
•
Use scissors to trim hair.
Step 5 – the final part
In the final stage of hair cutting, remove the
universal attachment (8) from the unit, set
the switch (6) to the upper position, turn the
IM VT-2578.indd 7 6/11/20 5:31 PM