8
ENGLISH
attachment until locking. Before cutting hair make sure
that the attachment is locked on its installation place.
To remove the attachment comb press the clamp and
remove the attachment.
Step one
Set the 3 mm attachment comb (5) or 6 mm attachment
comb (6).
Switch the unit on using the power switch (4), setting it
to position «
I
». Hold the hair clipper with the blades (1)
pointed upwards. Start cutting from the beginning of the
hair growth. Slowly move the trimmer upwards. This way
cut the head back area at neck bottom and near the ears
(pic. 3, 4, 5).
Step two
Switch the hair clipper off with the power switch (4) by
setting it to the position «
O
», unplug the unit, then set
the 9 mm attachment comb (7) for longer hair or 12 mm
attachment comb (8) and continue cutting hair near top
of the head (pic. 6).
Step 3 – cutting in the temples area
Switch the hair clipper off and unplug it, then set the 3
mm attachment comb (5) or 6 mm attachment comb (6)
and cut hair in the area of temples. Then set the 9 mm
attachment comb (7) or 12 mm attachment comb (8)
and continue cutting towards the top of the head (pic. 5).
Step 4 – cutting the crown of the head
Using the 9 mm attachment comb (7) or 12 mm attach-
ment comb (8), cut the hair on the top of the head
towards the crown against the hair growth direction
(pic. 6).
•
You can cut hair against and along the direction of
hair growth, but keep in mind that the hair cut against
the growth will be shorter than the hair cut along the
growth.
•
Use the 3 mm attachment comb (5) and 6 mm attach-
ment comb (6) for very short haircut. To leave a little
longer hair, use the 9 mm attachment comb (7) or
12 mm attachment comb (8).
IM VT-2570_70x130.indd 8
25.06.2019 14:12:38
